Hodgson Part 059, Valve Spring Cups

This entry is part 5 of 7 in the series Hodgson Cylinder & Heads

cup01The valve spring cups began life as a length of 10mm 416 stainless steel heat treated to HRC32-35. These parts get beat on by the valve spring retainer many times a second and I didn’t want any deformation occurring. Besides, heat treated material machines to a beautiful surface finish.

The first step was to rough turn the O.D. back about 1″.

cup02This was followed by center drilling, drilling and then reaming 0.1875″ diameter about 1″ deep as well.

cup03The finish cut for the 0.312″ outside diameter was next.

cup04With the parting tool set-up, a skim cut was made on the end of the stock to set the “0” point.

cup05The face was then counterbored 0.020″ deep with a 6mm end mill in the toolholder offset to bore the 0.250″ diameter.

cup06The parting tool was then reinstalled on the toolpost and the valve spring cup parted off about 0.001″ longer than the finished thickness.

These last 3 steps were repeated until the 1″ of material was used up and then the whole process was repeated two more times.

cup07After a quick trip to the surface plate with some 400 grit paper to lap the remaining 0.001″ from the parted-off backside, we have a fleet of valve spring cups.

Disclaimer and License

All material, including the CAD drawings, relating to the construction of the Hodgson Radial presented on this site is free to use any way you see fit. However, no guarantees are made regarding the accuracy or correctness of the material presented here.

Series Navigation<< Hodgson Part 058, ValvesHodgson Part 061, Valve Spring Retainers >>