Hodgson Part 013, Jackshaft

This entry is part 1 of 2 in the series Hodgson Jackshaft

jackshaft13I’ve mentioned before that obtaining quality material is one of my biggest problems here in China. Well, a corollary to that is that when I do have material, it’s probably not in the easiest-to-use form. For the jackshaft, I used a drop from a piece of 416 stainless plate that had been hardened to Rc35.

Before starting the Jackshaft, you should re-bore the G-175 gear so it can be used to size the shaft and you should have completed the front bearing and cam retainer plate for the same reason. It's always easier to adjust an outside diameter than an inside one to obtain the proper fit.

jackshaft01Since the material was in plate form, I sawed it into roughly 3/4″ X 3/4″ X 1-1/2″. The dimensions of 3/4″ X 3/4″ work pretty well because the piece just fits into a 1-1/16″ collet to rough it out.

jackshaft02With one end roughed down to 5/8″, and moved to a smaller collet for a more stable arrangement, I ready to start roughing the end with the long 0.25″ section. I chose to machine it this way so that when I flip the part to work on the other end, I can grip on the longest section.

jackshaft03First, I’ve turned the 0.500″ diameter well past the flanged area.

jackshaft04Next step is to face the end and note the carriage position so I can place the two shoulders coming up.

jackshaft05Since I reamed my front bearing and cam retainer plate oversized, I’m turning this 0.500″ long section to 0.251″. This will also make a nice press fit on the S-2412 steel gear so I can turn the whole length the same diameter.

jackshaft06Before I go on, I’m verifying that this is a good running fit on the front bearing.

jackshaft07The diameter of the 0.376″ step here is not critical, but the length forms one side of the gear flange so try to get that in the right place.

jackshaft08Since my stock was still about 0.4″ long over all, I chucked on the 0.500″ section to rough the other end down to 1/2″ diameter and within a few thousandths of the finished O.A.L.

jackshaft09Next, I re-chucked on the 0.25″ section, faced off the remaining few thousandths on the over all length, and zeroed the carriage position.

jackshaft10With my new length datum, I turned the 0.376″ diameter up to flange. Check this carefully – it should be a light press fit on the G-175 gear.

jackshaft11Once again, I’m turning this to 0.251″ to fit the bushing previously reamed in the cam retainer plate.

jackshaft12Now is the time to check and adjust the 0.25″ section for a good running fit on the cam retainer plate.

jackshaft13

 

 

 

 

The finished jackshaft ready to have the gears pressed on.

Disclaimer and License

All material, including the CAD drawings, relating to the construction of the Hodgson Radial presented on this site is free to use any way you see fit. However, no guarantees are made regarding the accuracy or correctness of the material presented here.

Series NavigationHodgson Part 014/015, Gears and Assembly >>